CALCULATION OF THE DYNAMIC ADJUSTMENT ERROR OF THE CUTTING EDGE WITH THE SURFACE TO BE PROCESSED

Authors

  • Fayzimatov Shukhrat Numanovich Fergana Polytechnic Insitute, DSc
  • YakupovArtur Mansurovich Tashkent State Technical University named after Islam Karimov,PhD
  • Gafurov Akmaljon Mavlonjonovich Fergana Polytechnic Insitute, PhD, Fergana Polytechnic Institute

Keywords:

Strength parameters, diagnostics, models, cutting area, strength, durability, stamping, stamping form, cutting parameters.

Abstract

In mechanical engineering, the detection of errors that occur during the processing of shaped surfaces of parts remains by far the most important task. Before processing the shaped surfaces, it will be necessary to study the working surfaces of the stamping molds. This article presents methods for determining the geometric parameters of the surface when processing stamping molds on shaped surfaces, in particular, information about the structure of the cutting zone of shaped surfaces, the penetration of the bit into the cutting zone and the control conditions in the cutting zone.

Downloads

Published

2024-05-14

How to Cite

Fayzimatov Shukhrat Numanovich, YakupovArtur Mansurovich, & Gafurov Akmaljon Mavlonjonovich. (2024). CALCULATION OF THE DYNAMIC ADJUSTMENT ERROR OF THE CUTTING EDGE WITH THE SURFACE TO BE PROCESSED. Innovative Technologica: Methodical Research Journal, 5(05), 1–9. Retrieved from https://it.academiascience.org/index.php/it/article/view/641

Issue

Vol. 5 No. 05 (2024): it.academiascience

Section

Articles

License

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.