DETERMINATION OF PARAMETERS BY SAMPLES CORE FROM THE OCCURRENCE OF PRODUCTIVE LAYERS

Authors

  • Salixova Ozoda Abdullayeva Candidate of Technical Sciences, Associate Professor of the Tashkent Institute of Chemical Technology
  • Xalmtova Nargiza Giyasovna Associate Professor of Tashkent State Technical University Named After Islam Karimov

DOI:

https://doi.org/10.17605/OSF.IO/7D8BQ

Keywords:

water saturation, oil saturation, paraffin, carbonate content, clay content, core, oil, gas, wells, resins, oils, asphaltenes, sulfur.

Abstract

The practice of processing test materials has shown that the most reliable data on the hydrodynamic characteristics of the formation is obtained by processing pressure recovery curves. Qualitative pressure curves during the inflow period serve as an addition to the information obtained from pressure recovery curves. Determination of average flow rates of inflow and fluid components. The percentage component-by-component composition of fluids is determined after lifting the sample accumulator and measuring the volume of fluid components. Extracted from the formation. Depending on the percentage composition, the specific gravity of the fluid (y, g / cm3) is calculated. In the future, y is used to calculate the average flow rate.

Downloads

Published

2023-02-27

How to Cite

Salixova Ozoda Abdullayeva, & Xalmtova Nargiza Giyasovna. (2023). DETERMINATION OF PARAMETERS BY SAMPLES CORE FROM THE OCCURRENCE OF PRODUCTIVE LAYERS. Innovative Technologica: Methodical Research Journal, 4(02), 103–108. https://doi.org/10.17605/OSF.IO/7D8BQ

Issue

Vol. 4 No. 02 (2023): it.academiascience

Section

Articles